[Note: The depth of the sealant bead should be approximately 1/2 of the joint width. Install the appropriate round backer rod, to the proper depth. Such cleaning can be accomplished in several ways (including power washing and hand-sanding), but cob-blasting with a Sashco Kernel is the fastest, easiest, and surest way to do the cleaning.If the inner “lips” of the checks are dirty or significantly weathered, then these “lips” (i.e., the surfaces of the check which will be in contact with the caulk or chinking) need to be cleaned, down to bare, “sound” wood – in order to ensure good adhesion of the stain and/or the caulk or chinking.Such a stain can act as a primer for the caulk or chinking and can greatly improve adhesion, especially when the walls are subjected to very wet weather.It is usually best to apply the log home stain that will be used over the general surface of the house to the inner lips of the checks to be caulked or chinked – if the stain is compatible with the caulk and chinking to be used. Either remove the standing water or let it evaporate away.Īs part of the overall application of a wood preservative, like Timbor or the Outlast Q8 Log Oil, to the surface of the logs, extra wood preservative should be applied into the checks that are to be sealed with caulk or chinking – then allowed to dry/cure prior to sealing. Make sure there is no standing water in the checks to begin with (otherwise, there is a great risk of rot and premature sealant failure. It is always best to perform the following steps when sealing checks with caulking or chinking (starting, of course, with appropriate weather!): Step-By-Step Process: How to Fill Gaps In a Log Cabin
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |